500N 50KG Digital Dynamometer Push Pull Force Gauge Tester Meter ELK-500

Description

ELK Series
Analog Dynamometer  Parameter:
Mode
ELK-2
ELK-3
ELK-5
ELK-10
ELK-20
ELK-30
ELK-50
ELK-100
ELK-200
ELK-300
ELK-500
The Max Load Value
2N
3N
5N
10N
20N
30N
50N
100N
200N
300N
500N
0.2kg
0.3kg
0.5kg
1kg
2kg
3kg
5kg
10kg
20kg
30kg
50kg
0.45Lb
0.65Lb
1.1Lb
2.2Lb
4.5Lb
6.5Lb
11Lb
22Lb
45Lb
65Lb
110Lb
Load Value Resolution
0.001N
0.01N
0.1N
0.001KG
0.001KG
0.01KG
0.001Lb
0.001Lb
0.01Lb
The sensor
Built-in Sensor
Precision
±0.5%
Power
3.7V lithium battery
Charging Time
4-6 hours
Continuous Usage Time
About 15 hours
Battery Life
≥300 times
Charger
Input AC 100-240V 50-60Hz   Output: DC 5V 1000mA
Working Temp.
5-35 centi-degree
Transportation Temp.
-10-60 centi-degree
Relative Humidity
15%-80%RH
Work Environment
No focus, Non-corrosive in surrounding
Item specifics
Display Type:
Digital
Max Load:
500N
Model Number:
ELK-500
Product Description
ELK-500 Digital Dynamometer Force Measuring Instruments Thrust Tester Digital Push Pull Force Gauge Tester Meter
Product Description:
This product is a simple push pull force gauge with high performance.
1.Digital display,easy reading;
2.In light weight,small size,easy to carry;
3.Unit display:Lb,Kg,N
4.The battery has over-load protection in case of short circuit and leakage of electricity .It also can tell you when the battery is running low.It adopt the 3.7V lithium battery and auto shut off with no operation in 10 minutes at the same time.
Screen display
1.Peak mode: After turn on,enter into the measuring interface,click “SET” button can enter into the peak mode directly,record the Max. force value during measuring.
2.Push pull force shows:do not move the gauge,the   above arrow shows the pull force,the below arrow shows the push force.
3.Measuring force value display.
4.Three units:N(newton),kg(kilogram),lb(pound) display respectively ,press “UNIT” button to switch .
5.Power display.
The key introduction
OFF/ON(start up ,shut down key):when press this key,turn on the power,appear measuring interface.Press this key again can shut down gauge.
ZERO(zero key)The testing value on the screen can be zero when click this key. UNIT( switch unit key)It can switch three different unit s when click this key.